![]() Once the cable modem has learned the MAC address of the first PC or equipment that talks to it, it will not respond to another MAC address in any way. Some cable ISPs (Vidéotron for example) have the cable modem configured to recognize only one client PC, by the MAC address of its network interface. For example, enable Troubleshooting Swapping computers on the cable modem Note: netctl includes otherwise you can use from the ifplugd package. If udev is not detecting and loading the proper module automatically during bootup, you can explicitly load the module at boot. You may search the AUR for the module name. Alternatively, it is possible that the driver is not included in the Arch kernel. If you get an error saying that the module was not found, verify first if you recently upgraded the kernel (see General troubleshooting#Cannot use some peripherals after kernel upgrade). Once you know which module to use, try to load it manually. Some common modules are 8139too for cards with a Realtek chipset, or sis900 for cards with a SiS chipset. Search the internet for the right module/driver for your chipset. ![]() Otherwise, you will need to know which module is needed for your particular model. Skip the next section if the driver was loaded successfully. For example:Ītl1 0000:02:00.0: eth0 link is up 100 Mbps full duplex Next, check that the driver was loaded by running dmesg | grep module_name as root. $ lspci -v 02:00.0 Ethernet controller: Attansic Technology Corp. It should tell you which kernel module contains the driver for your network device. Check the "Ethernet controller" entry (or similar) from the lspci -v output. Udev should detect your network interface controller (NIC) and automatically load the necessary kernel module at startup. This article describes Ethernet specifics, general network configuration is covered in Network configuration.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |